Seymour Duncan Triple Shot Switching Mounting Ring Set - Trembucker Sized Rings for Neck and Bridge Pickups

Seymour Duncan Triple Shot Switching Mounting Ring Set - Trembucker Sized Rings for Neck and Bridge Pickups

• Easy Wiring Mods - Simplify your wiring mods with the Triple Shot switching mounting ring, offering four distinct sounds at your fingertips. This flat Trembucker sized ring in black is perfect for guitars with non-arched tops.
• Tonal Variety - Experience a tonal variety with four unique sounds (splitting to either coil, series operation, and parallel operation). Easily switch between various sounds with just the flip of your finger.
• Effortless Installation - The Triple Shot is easy to hook up, eliminating the struggle with pushpull or mini-toggle connections—the Triple Shots color-code labeled solder pads are a snap to solder up. Imagine having coil splits on your 335 without having to pull the harness, and struggle to get the pots back in the right place
• Endless Combinations - One ring for each pickup means four sounds per humbucker. The combinations are almost endless. With this version, the neck & bridge rings are the same shape, size, and height.
• Convenient Switching - No more reaching for pushpulls, there are two small slider switches at the low E-string edge of the ring for easy access.

The Seymour Duncan TS-2 SET includes one TS-2n (Neck) and one TS-2b (Bridge) mounting rings for Les Paul Humbuckers. The TS-2 SET allows you to expand your tonal palette by accessing three unique tones from a humbucker, thanks to the TS-2 mounting ring that holds two small switches. For use with nearly any humbucker pickups with four-conductor cable on Les Paul guitars, Seymour Duncan or otherwise. This "stealth" pickup switching device allows you to access series, parallel and split wirings with a standard humbucker. And it's easy to install. Just solder your pickup leads to a small color-coded circuit board. That's it. Push the two switches towards each other for standard series wiring; away from each other for parallel wiring; and both towards one coil (either one) to shut that coil off. Specifications TS-2N (Neck) Inside: 2.780 x 1.470 inches Outside: 3.54 x 1.78 inches Pickup mounting hole spacing: 3.076 inches on center Trim ring mounting hole spacing: 3.20 x 1.513 inches on center Height: 0.200 inches (ring), 0.328 inches (switch casing) Circuit board: 1.353 x 0.402 inches Soundboard radius: 43.5 TS-2b (Bridge) Inside: 2.780 x 1.470 inches Outside: 3.54 x 1.78 inches Pickup mounting hole spacing: 3.076 inches on center Trim ring mounting hole spacing: 3.20 x 1.513 inches on center Height: 0.426 inches (ring), 0.554 inches (switch casing) Circuit board: 1.353 x 0.402 inches Soundboard radius: 20.4 Note: Will not fit Nickel and Gold covered Trembuckers.