Prime-Line R 7211 Drawer Slide Kit – Replace Drawer Track Hardware – Self-Closing Design –Fits Most Bottom/ Side-Mounted Drawer Systems –17-3/4 In. Steel Tracks, Plastic Wheels, White (1 Pair)

Prime-Line R 7211 Drawer Slide Kit – Replace Drawer Track Hardware – Self-Closing Design –Fits Most Bottom/ Side-Mounted Drawer Systems –17-3/4 In. Steel Tracks, Plastic Wheels, White (1 Pair)

• INSTALL OR REPLACE DRAWER TRACK HARDWARE – Whether you are installing new drawers or repairing one that won’t open or close properly, Prime-Line Drawer Slide Kit fits most bottom/side-mounted drawer systems. The drawer slide kit is constructed of steel tracks with a white powder coated finish and self-lubricating plastic rollers.
• SELF-CLOSING DESIGN – The smooth-gliding tracks in the Prime-Line R 7211 kit features a self-closing design that commences at the final 2-1/2 inch from the end of the 17-3/4 inch long tracks when closing.
• EASY TO INSTALL – Installation is quick and easy, and the kit contains all necessary fasteners. Installation instructions are included and also available on Prime-Line’s website.
• 75 LBS MAX LOAD CAPACITY – The maximum load capacity for the drawer slide kit is 75 lbs. and is for use in 18 inch deep drawer cabinets. It features a positive stop in the closed position and a double stop in the extended position that locks your drawer open, so it cannot be pulled too far out and fall off the tracks.
• INSTALLATION TIP – The clearance required between the drawer and the drawer opening for these slides is: 1/2 inch on left and right sides, 1/4 inch at the bottom and 5/8 inch at the top.

This drawer slide kit is constructed of steel tracks with plastic rollers, and it comes in a white powder coated finish. These tracks feature a self-closing design that commences at the final 2-1/2 in. from the end of the 17-3/4 in. long tracks when closing. The maximum load capacity for this kit is 75 lbs., and it fits most bottom/side-mounted drawer systems. This kit cannot be cut down to fit smaller drawer depths as it is designed with a positive stop at the ends of the fixed tracks, and because the rear rollers (11/16 in. diameter wheels) on the sliding tracks are fastened to the ends of the drawer-mounted track pieces. These bottom mount drawer slides can be installed in drawer cabinets with face frames and without. If installing in drawer cabinet with face frame, Prime-Line's model number R-7240 (purchased separately) may be necessary if existing back plates are damaged. The clearance required between the drawer and the drawer opening for these types of slides is as follows: 1/2 in. on left and right sides, 1/4 in. at the bottom and 5/8 in. at the top. Installation instructions are included with each set, and they can also be found within the manufacturer’s website.