Oxygen Sensor Socket with Side Wire Cutout, 1/2" Drive by 7/8" 6-Point O2 Sensor Fit All Vehicles O2 Removal and Installation, Offset Oxygen Sensor Socket, Car Accessories (Black, Large Opening)

Oxygen Sensor Socket with Side Wire Cutout, 1/2" Drive by 7/8" 6-Point O2 Sensor Fit All Vehicles O2 Removal and Installation, Offset Oxygen Sensor Socket, Car Accessories (Black, Large Opening)

• 【High Quality Material】: This oxygen sensor socket is made of hard chrome vanadium steel. It has high hardness and good load-bearing capacity, so it is not easy to be deformed or broken during use, suitable for long-term use. It adopts anti-rust technology, so it is not easy to rust or be corroded
• 【Practical Function】: The oxygen sensor is an important part of automobile engine fuel correction, it always fine tunes the air-fuel ratio to maintain the best air-fuel ratio in the engine cylinder. The purpose of this oxygen sensor socket is to install and remove the oxygen sensor, which is a tool for timely replacement in case of the oxygen sensor's failure
• 【Side Slot Design】: Carefully designed side slots allow the sleeve to slide smoothly into the oxygen sensor while keeping the sensor cable intact. This innovative design not only keeps the cable from being damaged, but also saves valuable time and effort during repair or replacement
• 【Easy to Use】: Our oxygen sensor socket can be used with ratchet wrench and disconnecting pliers, which is easy to operate. The standard 6-point slotted design provides you with extra leverage, which makes replacing or removing the oxygen sensor even easier
• 【Wide Application】: It measures 7/8 inch (22 mm) with a hex shape on the inside, so it is compatible with most oxygen sensors with 7/8 inch hex nuts. It is square at the top and the length of the inner edge is 1/2 inch (12.5mm) Please confirm the size before ordering