ENGINEER NZ-05 Full Flush Cut Chip Cutters, 45 Degree Angled Jaws Cutting Pliers for Quick & Easy Removal of ICS (DIL DIP SIP Packages etc.).Made in Japan

ENGINEER NZ-05 Full Flush Cut Chip Cutters, 45 Degree Angled Jaws Cutting Pliers for Quick & Easy Removal of ICS (DIL DIP SIP Packages etc.).Made in Japan

• jaw end angle set at 45 degrees (perfect for snipping components with the jaws positioned flush to a PCB circuit board)
• jaw opening angle adjuster - sets how wide jaws open when grips released (enhances productivity & less hand fatigue for repetitive cutting work)
• supplied with 1.5mm hex key wrench as standard accessory (to set the jaw opening angle adjuster)
• comfort cushioned grips , ESD compliant - made from oil resistant elastomer (strap holes at end of handles)
• heat treated carbon steel for excellent cutting performance & durability

Specialized cutters designed to remove unwanted components from an SMD or through hole PCBs, thereby allowing for easy desoldering/cleaning of the associated component PCB pad. Ideal for cutting the leads of D.I.P. and S.I.P. on densely populated SMD PCBS. Long-life carbon steel jaw construction, specially designed to prevent the pivot joint loosening or the blades going out of alignment. Opening angle adjuster (this sets the jaw gap when the handles are released - 1.5mm hex key supplied). ESD-Safe comfort grips made from TPR (Thermoplastic rubber). Cutting capacity - 0.6mm copper wire.