LEDwholesalers 12-Volt RGB Color-Changing Kit with Controller and IR Remote, Power Supply, and LED Strip with Water-Resistant Silicone-Gel Coating, 2038RGB-R2+3369+3208

LEDwholesalers 12-Volt RGB Color-Changing Kit with Controller and IR Remote, Power Supply, and LED Strip with Water-Resistant Silicone-Gel Coating, 2038RGB-R2+3369+3208

• Complete kit includes: controller with wireless IR remote, power supply, and water-resistant silicone-gel coated LED strip
• Set static colors, adjust brightness, select various auto color-changing modes via wireless IR remote
• LED strip is cuttable every 3 LEDs, approx. every 4", at designated cut marks, to fit various length requirements
• Flexible - fits just about any space one can imagine
• Eco friendly - uses very little energy, without harmful radiations

These LED color-changing flexible strips are great for nearly any application. Each kit comes with a 16.4 ft (5 meters) long LED light strip reel, controller with wireless IR remote, and the power supply. Everything needed to add great light to any location.<br> <br> <b>Specifications</b> (LED strip)<br> * LED Quantity/Type: 150x SMD5050 RGB<br> * Input Voltage: 12 VDC<br> * Power: 21.3 W<br> * Beam Angle: 120º<br> * Dimmable: Yes<br> * IP Rating: IP65<br> * Pin Order: +RGB<br> * PCB Color: White<br> * Width: 10 mm<br> * Length: 16.4 ft (5 m)<br> * Wire Leads: 22 AWG<br> * Compliance: CE, RoHS<br> * Life Expectancy: 35,000 h<br> * Warranty: 1 year<br> <br> <b>Wiring</b><br> * Unroll LED strip completely.<br> * Any exposed wires on the other end of the LED strip must not touch one another (or any metal object), creating a short.<br> * Connect the 4-pin connector of controller to that of the LED strip.<br> * Connect DC jack of power supply to controller.<br> * Remove the plastic seal in the battery compartment of the wireless remote.<br> * Double check that all connections are correct and secure, then plug in power cord.<br> <br> <b>Note</b><br> * While the included controller can handle the power requirement of two such strips, the power supply only has the capacity to drive a single strip.<br> * Do not lengthen the LED strip by directly connecting an additional section to it.<br> * Test all components before permanent installation.<br> * Make sure that wires at the other end of the LED strip are not touching one another (or any metal object), which would create a short circuit.<br> * The LED strip is cuttable every 3 LEDs, approx. every 4", at the designated cut marks.<br> * Only the LED strip is waterproof; all other components and connections must be protected from getting wet.<br> <br>