KINGPRINT MKS Gen V1.4 Controller Board+5PCS DRV8825 Stepper Motor Mega 2560 Motherboard RepRap Ramps1.4 Compatible +USB Cable for 3D Printer

KINGPRINT MKS Gen V1.4 Controller Board+5PCS DRV8825 Stepper Motor Mega 2560 Motherboard RepRap Ramps1.4 Compatible +USB Cable for 3D Printer

• The firmware can use open source firmware Marlin, ramps1.4 identical configuration and can directly replace Ramps1.4.
• Reserved for motor pulse and direction output ports for easy plug-in high-current To add a large current (eg 2A, 5A) motor drive circuit.
• Reserved Ramps1.4 on Servos, AUX-1, AUX-2 interface that provides three 5V output, three 12V outputs.
• The circuit board with high-quality 4-layer, heat and made a special optimization; ramps are 2 shelves.
• Can accept 24V input power under the same system can be hot-bed current is reduced to 1/4, an effective solution to the hot bed MOS pipe heat problems.

<b>Specification:</b> Can be connected to the control panel and 12864LCD Ramps1.4,2004LCD control panel.(Can't be sure to match all of stype of 12864LCD and 2004LCD ) <br> MEGA2560 and RAMPS 1.4 set on a board, to solve complicated RAMPS1.4 combination of interfaces, the problem of failure prone. <br> Support up to 5 motor driver (A4988 or DRV8825). <br> Using a dedicated power chip, support 12V-24V power input, the voltage converter chip to solve the heat problem Ramps. <br><br> <b>Package Included:</b> <br><br> 5 * DRV8825S Stepper Motor Driver<br> 1 * MKS-Gen V1.4 Controller Board<br> 1 * USB Cable<br> 5 * Mini Heat Sink<br>