Hold Fast Non-Stick Bushings for Ca Pen Finishing

Hold Fast Non-Stick Bushings for Ca Pen Finishing

• Make finishing easier
• No more bushings glued to barrels
• Material will not stick to pen barrels

Using CA glue to finish your pen turnings results in a lustrous, glossy polish, but it can also fuse your pen blank to the bushings. Not so with these non-stick polyethylene bushings in place, however. These bushings are made from UHMW, the same super-slippery polymer used in our Plastic Jig Stock. They're pre-drilled for a standard mandrel, and have a 60° taper so they'll fit most any size pen bushing. Just swap these for your metal bushings once the pen is turned, and apply your finish. 4-Pack. Features: Non-Stick Pen Bushings are made of UHMW (Ultra-High Molecular Weight) polyethylene Pre-drilled for a standard 7mm mandrel (e.g. 43537, sold separately) 60° cone-shaped taper fits any size pen bushing After shaping the pen blank, replace the metal bushings with non-stick plastic bushings and apply your CA finish Self-lubricating UHMW has a low coefficient of friction, so it sheds glue easily Very stable - 10x heavier than regular high-density polyethylene High abrasion resistance and high impact strength even at low temperatures Resistant to chemicals