Hobbypower PPM Encoder V2.0 for Pixhawk PPZ Mk MWC Megapirate APM Flight Controller

Hobbypower PPM Encoder V2.0 for Pixhawk PPZ Mk MWC Megapirate APM Flight Controller

• The PPM Encoder plugs into the PWM servo output ports of any R/C receiver and encodes them into a PPM pulse suitable for many autopilots (e.g. Pixhawk). Modifications to the R/C receiver are not necessary
• The whole project is based around the ATMEL ATMEGA328p AVR processor and all timing is done within interrupts so accuracy and stability is optimized
• Firmware is free and was created by John Arne and Olivier Adler
• The design of the PPM Encoder is based on the Paperazzi PPM Encoder
• The firmware comes pre-configured to read 8 Channels. In case you would like to change the settings of the PPM encoder to invert the PPM signal and change the fail safe pre-defined values you will need an AVR ISP programmer in order to reprogram it.

The PPM Encoder plugs into the PWM servo output ports of any R/C receiver and encodes them into a PPM pulse suitable for many autopilots (e.g. Pixhawk). Modifications to the R/C receiver are not necessary. <br /> <br /> The whole project is based around the ATMEL ATMEGA328p AVR processor and all timing is done within interrupts so accuracy and stability is optimized. <br /> <br /> Firmware is free and was created by John Arne and Olivier Adler. <br /> The design of the PPM Encoder is based on the Paperazzi PPM Encoder. <br /> <br /> Important Note: The firmware comes pre-configured to read 8 Channels. In case you would like to change the settings of the PPM encoder to invert the PPM signal and change the fail safe pre-defined values you will need an AVR ISP programmer in order to reprogram it. <br /> <br /> The jumper on the board no soldering default. In this case the board powered by FC <br /> Dimension(mm): 28 x 19 x 5 <br /> Weight(g): 9(include all wire) <br /> <br /> Package content (as picture shows) <br /> PPM Encoder x 1 <br /> 10Pin input cable 60mm x1 <br /> 4Pin output cable 100mm x1 <br />