Go Power GP-TS 30 Amp Pre-Wired Transfer Switch, Circuit Protected - Generator Transfer Switch with Built-in Inverter Cable and Receptacle, 120 VAC, 9.65" L x 7.28" W x 4.75" H, 3 lbs

Go Power GP-TS 30 Amp Pre-Wired Transfer Switch, Circuit Protected - Generator Transfer Switch with Built-in Inverter Cable and Receptacle, 120 VAC, 9.65" L x 7.28" W x 4.75" H, 3 lbs

• Quick Installation: Pre-wired with cables for quick and easy installation, reducing setup time and eliminating the need for additional wiring.
• Circuit Protection: Built-in circuit protection ensures safe operation, preventing electrical overloads and keeping your system secure.
• Inverter Compatibility: Includes a cable with a built-in plug to connect to the inverter output, simplifying integration with your solar system.
• Shore Power Control: Powers your converter only when shore power is available, optimizing energy efficiency and reducing battery use.
• Compact and Lightweight: With compact dimensions (9.65”L x 7.28”W x 4.75”H) and a weight of just 3 lbs, this transfer switch is easy to install and store.

Go Power! Prewired 30 Amp Automatic Transfer Switch is used to hardwire inverters into a system where there is an alternative source of AC. This transfer switch is made to only allow one source of AC power to pass through it to the loads and ensures that the inverter will not be damaged if the generator or utility power is hooked up while the inverter is running. It is prewired for a quick and easy installation to the existing system and also a includes a 15 Amp outlet on the side that is powered by the shore power or generator, permitting to hook up a battery charger without worrying about the inverter running the charger as well as well as contains all instructions.