DROK Micro Dual Power Supply - DC to DC Buck Boost Converter 4.8-35V to ±15V Positive Negative Dual Output, Step Up Voltage Regulator for OP-Amps

DROK Micro Dual Power Supply - DC to DC Buck Boost Converter 4.8-35V to ±15V Positive Negative Dual Output, Step Up Voltage Regulator for OP-Amps

• DROK micro voltage converter with low voltage input range DC 4.8-35V, positive and negative dual output voltage is ±15V, rated output current is 660mA.
• APPLICATION: the step-up regulator module is suitable for sensor, operational amplifier, audio and other devices that needs positive-negative power output.
• SMALL MODULE HIGH EFFICIENCY: DROK boost converter is with small dimension 64x27.5x12.5mm; the small module conversion rate can be up to 88%.
• TWO MOUNT METHODS: the volt transformer module not only support row pin welding, but also lead mounting, which will be convenient for your use.
• NOTE: please note that although the module is with short circuit protective function, it can not in long continuous short circuit, or it will be damaged.

<p> <strong>Parameters:</strong><br /> Input Voltage: 4.8~35VDC<br /> Output Voltage: ±15VDC<br /> Rated Current: 660mA<br /> Convert Efficiency: 88% (24V input at VIN）<br /> Minimum Load: 30 mA<br /> +/-Vo Ripple Noise of Bare Metal: 90mV/80mV<br /> Ripple Noise: 35mV/30mV (test condition: 24V input at VIN, bandwidth limit of 20MHz, full-load output)<br /> No-load Power Consumption: 530 ~ 550mW<br /> Short Circuit Protection: YES (the circuit can be self-restored from short circuit, but it does not support long continuous short circuit)<br /> Working Temperature: -40 ~ +85℃<br /> Dimension: 64 x 27.5 x 12.5 mm<br /> Port Function:<br /> VIN: positive of 4.8~40VDC voltage input <br /> GND : common ground connection port for input and output<br /> +Vo : output +<br /> -Vo : output -<br /> EN : Module enables: VEN<0.8V, module doesn't work; 1.4V<VEN<VIN or when EN doesn't connect to any wire, module works normally.<br /> </p> <p> <strong>Installation:</strong><br /> 1.Pin-type welding of embedded PCB board.<br /> 2.Lead terminal installation.<br /> <br /> <strong>Note:</strong><br /> 1. Voltage of EN and voltage of VIN should be different, or it may cause unstable output.<br /> 2.For low voltage input, user needs to refer to the curve of output derating use.<br /> <br /> <strong>Package Includes:</strong><br /> 1 * ±15V Dual Output Power Converter Module </p>