DCT Aluminum Pro Grip Clamp Straight Edge Wood Cutting Table Saw Guide, 50in / 127cm – Circular, Rotary, Jig, Router Silver

DCT Aluminum Pro Grip Clamp Straight Edge Wood Cutting Table Saw Guide, 50in / 127cm – Circular, Rotary, Jig, Router Silver

• INSTANT STRAIGHT EDGE GUIDE: When you have limited workshop space, the DCT Aluminum Pro Grip Clamp Straight Edge Wood Cutting Table Saw Guide, 50” Inch / 127cm – Circular, Rotary, Jig, Router will save you the space required for cutting/panel gluing and is capable of clamping to any parallel edge workpiece with low profile jaws that allow you to use the clamp inverted and have an unobstructed work area
• ALL-IN-ONE: You get a smooth, straight edge and a woodworking self-clamping tool in one handy unit so you can stack glue panels without worrying about them tipping and crashing to the floor; 58” x 2.1” x 0.5” inches (147cm x 5.3cm x 1.3cm) overall dimensions (stands 1.1 inches/2.8cm tall) with 2.5” x 1” x 0.25” inch (6.4cm x 2.5cm x 0.6cm) clamp
• BUILT TO LAST: Constructed with an aluminum body and reinforced with integral tube running the length of the wide body for maximum rigidness and lightweight handling; Wide and tall hard plastic jaws hold work piece securely and are predrilled for accessory; When clamped, this solid guide shows no play and it tightly holds its grip
• WIDE RANGE: Scale includes both inches and centimeter measurements and is adjustable to work over the full range up to 50 inches/127cm; T-track on guide accepts standard accessories including all Pro Grip accessories and also allows complete flexibility when designing specialty fixtures in your shop; Low profile and flat top easy on a rotary saw, jig saw, circular table saw, router straight cut, or joiner cut
• EASY TO USE: There are two clamps that hold the wood – a stationery clamp on the end with lever and a sliding clamp that moves along the rail; To adjust, pull the sliding clamp apart until you hear a click, adjust the clamp to the wood, hold the clamp against the wood and push the other part of the clamp towards the wood until it locks, make sure the stationary clamp has the handle in the upward position when adjusting and push the lever down to lock into place