Complete Edge Care Kit Base-Side Ski Edge Tool +3 Diamonds +Gumi Stone

Complete Edge Care Kit Base-Side Ski Edge Tool +3 Diamonds +Gumi Stone

• Complete Edge Care Kit - Everything you need to professionally sharpen ski and snowboard edges. Side and base edge bevel multi tool (does all angles) and includes a metal file with three diamond stones and a deburring gummi stone.
• This one tool is all you need to sharpen and bevel your edges for both the base and side edges. Dial a precise angle from 0 degree to 5 degrees in 0.5 degree increments. Does every angle imaginable!
• One Gumi or Gummi Stone for prepping an edge, deburring as the final step in edge sharpening, or detuning.
• Three RaceWax diamond stones (black, blue, red) included! se the black (coarsest) diamond stone for light cutting, the blue stone to hone the edge and maintain the sharpness, and the red (finest) stone for ultra-fine sharpening/polishing.

<p>Complete Edge Care Kit - Everything you need to professionally sharpen ski and snowboard edges.</p><p>Side and base edge bevel multi tool (does all angles) and includes a metal file with three diamond stones and a deburring gummi stone.</p><ul><li>Does both base and side! This one tool is all you need to sharpen and bevel your edges. Dial a precise angle from 0 degree to 5 degrees in 0.5 degree increments.</li><li>Metal file included!</li><li>One Gumi or Gummi Stone for prepping an edge, deburring as the final step in edge sharpening, or detuning.</li><li>Three diamond stones included! The brand of stone will vary depending on availability, but the colors (black, blue, red) remain the same; they will either be DMT or RaceWax branded diamond stones.</li><li>Use the black (coarsest) diamond stone for light cutting, the blue stone to hone the edge and maintain the sharpness, and the red (finest) stone for ultra-fine sharpening/polishing.</li><li>Bonus Benefit for this tool: If you don't know what base and side angles your ski/board are set to, this tool can help you find them. Before you start mark the metal edge with a sharpie, start the tool at the lowest angle and see if it removes the marking on your edge. Raise the angle step-wise and repeat until it removes the mark. That is your angle! Record the base/side angles for future reference.</li><li>There are two ways to determine the cutting direction for the metal file in the tool: (a) you can run the back of your fingernail across the file. Your fingernail will run smoothly one way and the other way (the cutting direction) will produce small shavings from your fingernail on the file; or, (b) look closely at the file with a magnifying glass. You will see that the file teeth point in only one direction. You pull the file in the direction that will cause the most friction against the ski edge (the cutting direction). </li></ul>