Command Wire Adhesive Hook

Command Wire Adhesive Hook

• 15 Wire Hooks Total (5 Packs of 3 Sets of Wire Hooks Each)
• Damage-Free Hanging
• Holds strongly, Works on a variety of surfaces
• Removes cleanly, Easy to apply and remove
• Holds up to 225g / 1/2 lb

Details3 per pack 3m command hooks. 4 Small strips. Holds on strong; Each 3m command hook holds 1/2 lb (225 g). Hooks can be reused with Command Adhesive Small Strips. Limited warranty. Hooks made in Taiwan. 3m command products made in U.S.A.DirectionsFollow instructions carefully! Save instructions for clean removal in the future! To Mount Hook: Clean Surface: Use isopropyl rubbing alcohol, wipe lightly, let dry. Do not use household cleaners. Apply Strip: Remove red Command Adhesive liner. Align square end with edge of hook. Press firmly. Press Firmly! - Remove black wall side liner. Position hook and press entire hook firmly for 30 seconds. Wait 1 hour before use. To Remove Hook: Grab Removal Tab - To prevent hook from snapping your fingers, hold hook as shown. Do not press hook against wall. Slowly slide the tab straight down against the wall stretching the strip at least 6 inches (15 cm) until hook releases from the wall. Never pull the strip out at an angle. Strip could break or damage the surface. Note: Apply to surfaces above 50 degrees F (10 degrees C). Adhesive could soften and lose adhesion above 105 degrees F (40 degrees C).