CONFAST 1/2" x 3-3/4" Stainless Steel Wedge Anchor (25 per Box)

CONFAST 1/2" x 3-3/4" Stainless Steel Wedge Anchor (25 per Box)

• <b>MADE FROM 304 STAINLESS STEEL</b> - Can be used in wet, submerged environments and will not rust
• <b>WIDE RANGE OF SIZES</b> - Insures proper fastener for best results
• <b>PACKAGED WITH NUTS AND WASHERS</b> - Fast, quick, complete installation
• <b>HOLE SIZE IS ANCHOR SIZE</b> - Simplicity and ease of installation

<p><b>Applications</b><br>The anchor is made from 304 Stainless Steel. This anchor is designed for use in Concrete only, and should never be used in block or brick base material. </p><p><b>Environment</b><br>The anchor is designed for use in a Wet environment.</p><p><b>Hole Diameter/Bit Diameter</b><b><br></b>The anchor requires a 1/2" hole to be drilled in the base material (Concrete only). The hole should be drilled with carbide tipped bit that meets ANSI standards and used in a hammer drill.</p><p><b>Diameter of Anchor </b><br>The diameter of the anchor is 1/2".</p><p><b>Length Anchor </b><br>The length of the anchor is 3-3/4"</p><p><b>Thread Length</b><br>The length of the threads on the anchor is 2-1/4" in length.</p><p><b>Minimum Embedment</b><br>The minimum anchor embedment into the concrete is 2-1/4". Therefore, the anchor must be installed so that a minimum of 2-1/4" of the anchor is embedded into the concrete.</p><p><b>Maximum Fixture Thickness</b><br>The maximum fixture thickness or the maximum thickness of the material being fastened for a anchor is 1". This will ensure that the minimum embedment of 2-1/4" will be met.</p><p><b>Fixture Hole Diameter</b><br>The hole in the fixture or material being fastened must be larger than the designated diameter of the anchor. The 1/2" diameter anchor requires the hole in the fixture to be 5/8".</p><p><b>Torque Value</b><br>To be set properly in the concrete, the anchor must be torqued to between 50 - 60 ft./lbs.</p><p><b>Spacing between Anchors</b><br>Each anchor must be spaced a minimum distance of 5" from each other when measured center to center.</p><p><b>Edge Distance</b><br>It is very important not to install the anchor any closer than 2-1/2" from an unsupported edge of the concrete.</p>