Adygil Bank Sinker Mold with 5 Cavities and

Adygil Bank Sinker Mold with 5 Cavities and 1,2.3-Ounce,Without Handle

Bank Sinker Mould With 5 Cavities and 1,2,3-Ounce How to make sinkers: 1. Ensure you are wearing protective clothing and all care must be taken when heating and pouring lead. 2. Put scrap lead into saucepan and heat until molten (lead will normally melt at 650 degrees). 3. Once lead is molten use a cooking spoon to take away any impurities that have risen to the top. 4. Take your coat hanger wire (wire is only used when making sinkers that require a hole in the centre) and place within the mould. 5. Using the tongs grab tour mould carefully and have the pouring cavity facing you. 6. Pour molten lead into mould until cavity is full. 7. It is recommended the mould be preheated before use. 8. Once mould has been heated up and your lesd is fully molten and clean you can proceed to pour the lead in to the cavity. 9. Wait 10 seconds and using pliers pull wire out then proceed to open mould. 10. Using your pliers snip the excess lead of the top of the sinkers. 11. Good luck and remember to always take care. 12.When disposing of unwanted lead please take note of your local authority about appropriate methods. Warning: 1. Lead is a toxic material 2. Use PPE when handing moulds 3. Use dry moulds as water can cause molten lead to explode
Country USA
Brand Adygil
Manufacturer Adygil Fishing Tackle
Binding Sports
Color Silvery
Height 1.22
Length 3.9
Weight 0.80689187892
Width 2.56
Size Small
ReleaseDate 0000-00-00

Country	USA
Brand	Adygil
Manufacturer	Adygil Fishing Tackle
Binding	Sports
Color	Silvery
Height	1.22
Length	3.9
Weight	0.80689187892
Width	2.56
Size	Small
ReleaseDate	0000-00-00

Adygil Bank Sinker Mold with 5 Cavities and 1,2.3-Ounce,Without Handle

Customers who purchased this also purchased....